The following is an overview of the user manual for the Z-Wave product s Z-Wave Plus Wireless Receptacle (RFTR9605-T)from Eaton. To view other Z-Wave products and manuals from Eaton follow that link.
Overview
Features & Benefits:
• Rated for up to ½ HP motor loads
• Provides Z-Wave control of one outlet leaving the other one for normal use
• Safety shutter system prevents insertion of foreign objects into receptacle
• Can be associated with up to 5 other devices
• Blue LED at center illuminates to indicate ON/OFF status
• Patented indicator system alerts if receptacle is not set up in the network
• Single pole and 3-Way control: Use with standard 3-Way switch or Z-Wave Plus Accessory RF9617
• Neutral is required for installation
• Supports Z-Wave Plus technology including S2 Security certification for advanced encryption & cybersecurity
• Voice and app based control when used with compatible Z-Wave controller
Security
As a Z-Wave Plus certified product, s Z-Wave Plus Wireless Receptacle supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Eaton describes s Z-Wave Plus Wireless Receptacle as having the following features:
- Electric Load Type
- Firmware updatable via a compatible Z-Wave gateway
- Switch Load Capacity Current
- Neutral Wire Required
- Switch Type
- Z-Wave Scene Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. To exclude this device from a Z-Wave network, select the setting on your Z-Wave controller for exclusion
(Uninstall, Remove Device, Remove Node, Exclude Device, etc.).
2. Once your controller is in exclusion mode, press the device ON/OFF button one time to exclude it from the network. The LED will start blinking.
1. To include this device in a Z-Wave network, select the command on your Z Wave controller for inclusion (Install, Add Device,
Add Node, Include Device, etc.). Then press the device ON/OFF button one time to include it in the network.
2. Based on the controller, the controller may ask you to scan the QR code or manually enter 5 digit code under the QR code
to install the device as a secured device. You may find this QR code on the device or included in device packaging.
3. After the Device is added to the network, the blue indicator LED will stop blinking. This indicates the device is installed in the Z-Wave
network.
Factory reset s Z-Wave Plus Wireless Receptacle
Please use this procedure only when the network primary controller is missing or otherwise inoperable
The device could be reset locally. This will cause the device to be excluded from its network and restore to factory default.
Before leaving the network the switch will send a notification to the controller indicating its departure from the Z-Wave network.
1. Turn the device ON.
2. Press and hold ON/OFF button for 20 second till the LED flashes for the third time.
3. Release the ON/OFF button.
4. LED will start flashing rapidly. Once the LED starts blinking slowly, that indicates the device is not part of the network.
Please note that this is a user manual s Z-Wave Plus Wireless Receptacle from Eaton is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have s Z-Wave Plus Wireless Receptacle and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.