Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

Gc3 (2GIG-GC3-345) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Gc3 (2GIG-GC3-345)from 2GIG. To view other Z-Wave products and manuals from 2GIG follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
2GIG GC3
SKU Code
2GIG-GC3-345
Description
The GC3 is the most capable and robust system that 2GIG has ever made. With a 7” color, capacitive touch screen and a full upgrade to the user-interface, GC3 installation time is 30% faster and more accurate, too. UI features include single screen zone programming, elimination of unnecessary or redundant steps, One-Touch Arming, and easy-to-see Status. These features, along with many others, make GC3 the easiest, most intuitive experience of any security system in the industry.

Smart Home Control has been at the heart of all 2GIG panels since the very beginning. The new GC3 panel makes working with smart home devices simpler than ever before. Programming new smart home devices is a snap. Each GC3 comes equipped with a Z-Wave module making it ready to be the heart of Smart Home right out of the box.
Version #
HW: 0 FW: 4.05:02.00 was the version certified
Certification #
ZC10-16015004
Certified
2016-01-06T10:44:52.2952
Z-Wave Version
6.51.06

Security

As a Z-Wave Plus certified product, Gc3 supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    2GIG describes Gc3 as having the following features:

    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    From the Home Screen enter System Settings using the Master Code. Tap on Smart Home Settings and then tap on the Remove Devices tile. This will put the GC3 panel into exclusion mode. Trigger device to be revmoved following the device's instructions. The system will give a notification when the device has been removed.

    From the Home Screen enter System Settings using the Master Code. Tap on Smart Home Settings and then tap on the Add Devices tile. This will put the GC3 panel into listening mode. Trigger device to be added following the device's instructions. The system will give a notification when the device has been added.

    Factory reset Gc3

    From the GC3 Home Screen enter System Settings using the Master Code. Tap on Smart Home Settings and then tap on the Advanced Settings tile. Tap on the Reset Controller tile. The system will present a confirmation. Tap the confirmation. The system will reset the GC3 Z-Wave network. Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.

    Place the primary controller into inclusion mode. From the GC3 Home Screen enter System Settings using the Master Code. Tap on Smart Home Settings and then tap on the Advanced Settings tile. Tap on the Controller Learn tile to put the GC3 into learn mode. With the primary controller in inclusion mode, the GC3 will be added to the network.

    Please note that this is a user manual Gc3 from 2GIG is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Gc3 and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.