The following is an overview of the user manual for the Z-Wave product Gewa Andromeda Socket UK (419881)from Abilia AB. To view other Z-Wave products and manuals from Abilia follow that link.
Overview
Gewa Andromeda socket is specially adapted for disabled people who want to live a more independent life, such as wireless, can turn on/off lights, turn on/off various devices and can easily be moved between different outlets.
Flexible control modes
It can be controlled in three different ways, with an IR transmitter (GewaLink system), a radio transmitter (Z-Wave) or a connected control switch.
Built-in on/off button
Andromeda Socket also has a built-in on/off switch that makes you always can operate the device even if one has no IR/radio transmitter. It also has a blue indicator light that shows if the switch is on.
Easy to program
It is easy to program, as is done with the built-in on/off button.
Andromeda socket available in different versions for different countries.
Technical data
Operating voltage: 230V AC, 50 Hz
Maximum load: 2990VA 13A resistive load
Programming Channels IR: GewaLink channels
Radio: Z-wave
Radio frequency: 868.42 MHz
Socket for control switch: 3.5 mm (2-pole mono female)
Operating environment: indoors (IP 21)
Dimensions: 53 x 122 x 43mm (excluding connector plug)
Security
As a Z-Wave Plus certified product, Gewa Andromeda Socket UK supports Z-Wave S2 security. The following security modes are directly supported:
Features
Abilia describes Gewa Andromeda Socket UK as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Put your system controller into inclusion mode by following the instructions provided by your controller manufacturer.
2. Press the push Off/On button located on the front of the device three times within 1.5 seconds.
1. Put your system controller into exclusion mode by following the instructions provided by your controller manufacturer.
2. Press the push Off/On button located on the front of the device three times within 1.5 seconds.
Factory reset Gewa Andromeda Socket UK
Note: Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.
1. Press and hold the push button located on the front of the device for approx. 6 seconds until the LED's is steady.
2. Release the button and press ones again within 3 seconds.
Please note that this is a user manual Gewa Andromeda Socket UK from Abilia AB is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Gewa Andromeda Socket UK and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.