The following is an overview of the user manual for the Z-Wave product Door-/Window Sensor Bypass (PLMK10100)from ABUS. To view other Z-Wave products and manuals from ABUS follow that link.
Overview
Security
As a Z-Wave Plus certified product, Door-/Window Sensor Bypass supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
ABUS describes Door-/Window Sensor Bypass as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: The DSK code (Device-Specific-Key) is the device-specific key of your device and is required for secure teach-in (inclusion) via S2 at the gateway. The first 5 digits of the DSK code can be found on the QR Code on the right side of the product. Please enter them in the inclusion process when prompted. Alternatively, you can transfer the entire DSK code that you find on the enclosed DSK card to the gateway via QR Code Scan. Please keep the DSK card in a safe place!
Activate the inclusion mode (teach-in mode) on the gateway. (for more details, refer to the operating instructions of the gateway)
Or, in your Z-Wave app, press the "+" button (Add / Inclusion) and follow the instructions to set the gateway to inclusion mode.
Keep the device within range of the gateway.
Remove the safety strip from the battery compartment. We recommend using only the original Duracell battery supplied.
Then press the Link button 3 times quickly (within 1.5 seconds) using the pin to start the inclusion on the device.
The LED starts flashing green for up to 60 seconds
The successful inclusion is displayed in the app or on the gateway and the status LED on the device lights green for 2 seconds. Repeat the inclusion process if it was not successful.
If a new attempt fails as well, first carry out a factory reset on the device, see 2.5.
Activate the exclusion mode on the gateway. (for more details, refer to the operating instructions of the gateway)
Press the "-" button (Remove / Exclusion) in your Z-Wave app and follow the instructions to set the gateway to Exclusion mode.
Using the pin, press the Link button 3 times quickly (within 1.5 seconds) to start the exclusion on the device. The LED starts flashing red for up to 60 seconds
The successful exclusion is displayed in the app or on the gateway and the status LED on the device lights up red for 2 seconds.
Press the Link button once to wake up the device. It will then establish a connection to the Z-Wave gateway and transmit the current status.
Factory reset Door-/Window Sensor Bypass
Press and hold the Link button for at least 5 seconds. Release the button when the red LED stops blinking and lights up continuously. The device is now reset to factory settings.
Hint:
This procedure should only be used if the primary gateway is not capable of acting. If the device is set to factory default, the status is set to "not included" and the association settings and possible configurations are reset to default.
Please note that this is a user manual Door-/Window Sensor Bypass from ABUS is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Door-/Window Sensor Bypass and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.