The following is an overview of the user manual for the Z-Wave product Keypad (PLBE10000)from ABUS. To view other Z-Wave products and manuals from ABUS follow that link.
Overview
Users receive direct feedback via LEDs and/or loudspeakers on various actions
Faults (battery, inevitability, reception) can be quickly verified by 3 LEDs
Keypad wakes up automatically when approaching (< 20cm)
Easy to install on walls, incl. mounting bracket
Sabotage protection, push message e.g. when battery is low
Updates Over-the-Air (OTA), AES-128-bit encrypted, Z-Wave compatible
Security
As a Z-Wave Plus certified product, Keypad supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Access Control
Features
ABUS describes Keypad as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: The first 5 digits of the DSK code can be found on the QR Code on the back of the product.
If your Z-wave controller does not support SmartStart, follow these instructions for Product Classic Inclusion:
Activate the inclusion mode (teach-in mode) on the Z-Wave controller. (for more details, please refer to the Z-Wave controller's user manual)
Or press the "+" button (Include / Add) in your Z-Wave app and follow the instructions to set the Z-Wave controller to include mode.
Keep the device within range of the Z-Wave controller.
Press the Link button 3 times quickly (within 1.5 seconds) to start the inclusion on the device.
The Link LED starts flashing green for up to 60 seconds
Successful inclusion is displayed in the app or on the Z-Wave controller and the link LED on the device lights up green.
Repeat the inclusion process if it was not successful.
If a new attempt fails as well, first carry out a factory reset on the device, see 2.5.
Activate the exclusion mode (learn mode) on the Z-Wave controller. (for more details, please refer to the Z-Wave controller's user manual)
Or press the "-" button (Remove / Exclusion) in your Z-Wave app and follow the instructions to set the Z-Wave controller to Exclusion mode.
Press the Link button 3 times quickly (within 1.5 seconds) to start the exclusion on the device.
The Link LED starts flashing green for up to 60 seconds
The successful exclusion is displayed in the app or on the Z-Wave controller and the link LED on the device lights up green.
It´s a FLIRS device and hence does not support wake up command class
Factory reset Keypad
Press and hold the Link button for at least 5 seconds. The device is now reset to factory settings.
Hint:
Please use this procedure only if the primary network controller is missing or otherwise not functional.
If the device is set to factory default, the status is set to "not included" and the association settings and possible configurations are reset to default.
Not applicable
Not applicable
Please note that this is a user manual Keypad from ABUS is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Keypad and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.