The following is an overview of the user manual for the Z-Wave product Nexello Outdoor Siren (PLSG10100)from ABUS. To view other Z-Wave products and manuals from ABUS follow that link.
Overview
The settings for alarm duration, volume and the siren LED can be flexibly configured.
Is the alarm duration too long? Or want the LED of the outdoor siren to alert you of the enabling and disarming of the alarm system? Various parameters can be individually adjusted. The desired configuration is carried out in a few simple steps via ABUS Nexello.
The outdoor siren can be operated completely 100% wirelessly using batteries or an external power supply and can be freely positioned using a wall bracket with a set of dowels and screws. It has a cover contact and wall contact as protection against tampering. The siren indicates an imminent battery replacement or power failure, via a push notification to the free Nexello app.
Security
As a Z-Wave Plus certified product, Nexello Outdoor Siren supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
ABUS describes Nexello Outdoor Siren as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Press the Link button 3 times quickly (within 1.5 seconds) to start the inclusion on the device.
Press the Link button 3 times quickly (within 1.5 seconds) to start the exclusion on the device.
SmartStart location
SmartStart QR code's location as follows: The DSK code (Device-Specific Key) is the device-specific key of your device and is required for secure inclusion (teach-in) via S2 on the Z-Wave controller. The first 5 digits, known as the PIN Code, of the DSK can be found underneath the QR Code on the side of the product.
The device is a FLiRS (Frequently Listening Receiver Slave) and therefore does not require a wake-up function. The outside siren can be controlled by the Z-Wave controller at any time.
Factory reset Nexello Outdoor Siren
Press the Link button 3 times quickly (within 1.5 seconds). Press quickly (within 1 second) a fourth time and hold down the Link Button for at least 5 seconds.
The siren is now reset to factory settings.
Please note that this is a user manual Nexello Outdoor Siren from ABUS is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Nexello Outdoor Siren and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.