The following is an overview of the user manual for the Z-Wave product Z-Wave 230V relay module (PLHA10000)from ABUS. To view other Z-Wave products and manuals from ABUS follow that link.
Overview
Each relay can be turned on/off individually using Z-wave commands or using the switches connected to the module. At 230V voltage, this module can support up to 2*4.3A output, 2*1000W resistive load.
This unit is to be installed and sealed inside an electrical switch box.
Security
As a Z-Wave Plus certified product, Z-Wave 230V relay module supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
ABUS describes Z-Wave 230V relay module as having the following features:
- Color
- Firmware updatable via a compatible Z-Wave gateway
- Loads Controlled
- Neutral Wire Required
- Switch Load Capacity Watts
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: The DSK Code (Device-Specific-Key) is the device-specific key of your device and is required for secure teach-in (including) via S2 at the gateway. The first 5 digits of the DSK code can be found on the QR code label on top of the product. Please enter these in the inclusion process when prompted. Alternatively, you can transfer the entire DSK code found on the enclosed DSK card to the gateway via QR code scan. Please keep the DSK card in a safe place!
Activate the inclusion mode on the gateway. (for further details please refer to the gateways manual)
Press the "+" key (Add / Inclusion) in your Z-Wave app and follow the instructions to set the gateway to Inclusion mode.
The unit supports SmartStart function, where inclusion is initiated automatically on power-on, and repeated at dynamic intervals for as long as the device is not included into a Z-Wave network. Z-Wave SmartStart is based on the embedded SDK 6.8x and requires related gateway software components. The LED starts flashing.
Alternative Inclusion:
If the automatic inclusion did not work, instead press the Link button 3 times quickly (within 1.5 seconds) to start the inclusion on the device.
Activate the exclusion mode at the gateway. (for further details please refer to the gateways manual)
Press the "-" key (Remove / Exclusion) in your Z-Wave app and follow the instructions to set the gateway to exclusion mode.
Press the Link button 3 times quickly (within 1.5 seconds) to start the exclusion on the device.
Factory reset Z-Wave 230V relay module
Press the Link button 3 times quickly (within 1.5 seconds).
Press quickly (within 1 second)
a fourth time and press and hold the Link button for at least 5 seconds.
The button is now reset to factory settings.
Hint:
Please use this procedure only when the network primary controller is missing or otherwise inoperable.
If the device is set to factory default, the status is set to "not included" and the association settings and possible configurations are reset to default.
Please note that this is a user manual Z-Wave 230V relay module from ABUS is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave 230V relay module and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.