The following is an overview of the user manual for the Z-Wave product Z-Wave Gateway (SHGW10000)from ABUS. To view other Z-Wave products and manuals from ABUS follow that link.
Overview
Security
As a Z-Wave Plus certified product, Z-Wave Gateway supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Access Control
- S2 Authenticated
- S2 Unauthenticated
Features
ABUS describes Z-Wave Gateway as having the following features:
- Sensors
- Communications Connections
- Firmware updatable via a compatible Z-Wave gateway
- Communications Protocol
- Supported Notification Types
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Open the App ABUS Z-WAVE ONE and press the ""+"" button under the ""Device"" menu, the Gateway will go into inclusion mode. User can now trigger the Z-Wave device into its inclusion mode and add it to the Gateways Z-Wave network.
Open the App ABUS Z-WAVE ONE and press the ""-"" button under the ""Device"" menu, the Gateway will go into exclusion mode. User can now trigger the Z-Wave device into its exclusion mode and remove it from the Gateways Z-Wave network.
Factory reset Z-Wave Gateway
Open the App ABUS Z-Wave ONE and go to ""Home Settings"" > ""Gateway settings"" > ""Admin"" > ""Z-Wave administrator"" page, click ""Z-Wave Reset"" will reset the Z-Wave Settings of the Gateway.
If this controller is the primary controller for your network, resetting it will result in the nodes in your network being orphaned and it will be necessary after the reset to exclude and re-include all of the nodes in the network. If this controller is being used as a secondary controller in the network, use this procedure to reset this controller only in the event that the network primary controller is missing or otherwise inoperable.
Open the App ABUS Z-WAVE ONE and go to ""Home Settings"" > ""Gateway settings"" > ""Admin"" > ""Z-Wave administration"" page, click ""Z-Wave Learn Mode"" will put the Gateway into learn mode
Please note that this is a user manual Z-Wave Gateway from ABUS is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Gateway and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.