The following is an overview of the user manual for the Z-Wave product Z-Wave Indoor Siren (SHSG10000)from ABUS. To view other Z-Wave products and manuals from ABUS follow that link.
Overview
Security
As a Z-Wave Plus certified product, Z-Wave Indoor Siren supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
ABUS describes Z-Wave Indoor Siren as having the following features:
- Color
- Switch Load Capacity Watts
- Battery powered using Lithium batteries
- Firmware updatable via a compatible Z-Wave gateway
- Switch Load Capacity Volt-Ampere
- Outdoor Use
- Switch Load Capacity Current
- Battery Quantity
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset Z-Wave Indoor Siren
Press the Network-button for 10 seconds to factory reset the device
Note:
1, This procedure should only be used if the primary gateway is not capable of acting.
2, If the multi-sensor is set to the factory setting, the status is set to ""not included"", the association settings and possible configurations are reset to default.
A.) Set the Gateway/Controller into exclusion mode (Click the - (Remove) button in your Z-Wave App and follow the further instructions)
B.) Press the Network-button 3 times within 1.5 seconds and the Status-LED will flash 3 times If the Remove device process is successful, the Status-LED flash 6 times.
C.) Repeat the inclusion process from step B if it was not successful.
A.) Plug the SHSG10000 into a socket
B.) Set the Gateway/Controller into inclusion mode (Click the + (Add) button in your Z-Wave App and follow the further instructions)
C.) Press the Network-button 3 times within 1.5 seconds and the Status-LED will flash 3 times
D:) If the Add device process is successful, the Status-LED will turn off.
E: Repeat the inclusion process from step B if it was not successful.
Please note that this is a user manual Z-Wave Indoor Siren from ABUS is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Indoor Siren and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.