The following is an overview of the user manual for the Z-Wave product Z-Wave LED Lampe (SHLM10010)from ABUS. To view other Z-Wave products and manuals from ABUS follow that link.
Overview
Security
As a Z-Wave Plus certified product, Z-Wave LED Lampe supports Z-Wave S2 security. The following security modes are directly supported:
Features
ABUS describes Z-Wave LED Lampe as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Communications Protocol
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
A.) Screw the LED bulb into a standard E27 socket
B.) Click the + (Add) button in your Z-Wave App and follow the further instructions
c.) Turn the light-switch on. The App will show if the Add device process was successful and the LED-bulb will flash once. Repeat the inclusion process from step B if it was not successful.
A.) Click the - (Remove) button in your Z-Wave App and follow the further instructions.
B.) Switch the LED bulb on. The App will show if the Remove device process was successful. The LED bulb will flash once and then dim to 5%. Repeat the exclusion process from step A if it was not successful.
Factory reset Z-Wave LED Lampe
1. Switch the Power supply oft he LED bulb ON and OFF 6 times in a row. (Interval of 0.5 to 2 seconds)
2. When switched on for the 7th time, the LED bulb flashes twice indicating successful reset to factory settings.
Note:
1, This procedure should only be used if the primary gateway is not capable of acting.
2, If the multi-sensor is set to the factory setting, the status is set to ""not included"", the association settings and possible configurations are reset to default.
Please note that this is a user manual Z-Wave LED Lampe from ABUS is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave LED Lampe and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.