The following is an overview of the user manual for the Z-Wave product Z-Wave Magnetic Contact (SHMK10000)from ABUS. To view other Z-Wave products and manuals from ABUS follow that link.
Overview
Security
As a Z-Wave Plus certified product, Z-Wave Magnetic Contact supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
ABUS describes Z-Wave Magnetic Contact as having the following features:
- Battery Quantity
- Battery powered using CR2 batteries
- Color
- Communications Protocol
- Firmware updatable via a compatible Z-Wave gateway
- Outdoor Use
- Sensors
- Supported Notification Types
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
- Wake up Notification is transmitted every 24 hours by default.
- Wake up Notification is transmitted after Notification Report is transmitted
A.) Click the - (Remove) button in your Z-Wave App and follow the further instructions.
B.) Press the Tamper-button 3 times within 1.5 seconds and the Status-LED on the base unit front will flash 3 times. The App will show if the Remove device process was successful and the Status-LED on device will flash 6 times. Repeat the exclusion process from step A if it was not successful.
Factory reset Z-Wave Magnetic Contact
1. Press the Tamper-button 3 times within 1.5 Seconds
2. The device is now restored to factory settings
Note:
1, This procedure should only be used if the primary gateway is not capable of acting.
2, If the multi-sensor is set to the factory setting, the status is set to ""not included"", the association settings and possible configurations are reset to default.
A.) Slide the base unit from the mounting plate and remove the safety strip from the battery compartment.
B.) Click the + (Add) button in your Z-Wave App and follow the further instructions
C.) Press the Tamper-button 3 times within 1.5 seconds and the Status-LED on the base unit front will flash 3 times. The App will show if the Add device process was successful and the Status-LED will turn off. Repeat the inclusion process from step B if it was not successful.
Please note that this is a user manual Z-Wave Magnetic Contact from ABUS is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Magnetic Contact and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.