The following is an overview of the user manual for the Z-Wave product Z-Wave Multisensor (SHBW10000)from ABUS. To view other Z-Wave products and manuals from ABUS follow that link.
Overview
Security
As a Z-Wave Plus certified product, Z-Wave Multisensor supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
ABUS describes Z-Wave Multisensor as having the following features:
- Sensors
- Supported Notification Types
- Battery Quantity
- Firmware updatable via a compatible Z-Wave gateway
- Battery powered using CR123A batteries
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
A.) Click the - (Remove) button in your Z-Wave App and follow the further instructions.
B.) Press the Button on the device once. The App will show if the Remove device process was successful. Repeat the exclusion process from step A if it was not successful.
A.) Click the + (Add) button in your Z-Wave App and follow the further instructions
b.) Press the Button on the device once. The App will show if the Add device process was successful. The Status LED will light up for 2 seconds. Repeat the inclusion process from step A if it was not successful.
Short press button for 3 times (within 1.5 Sec) then the sensor sending wake up notification to gateway, wake up for 10 seconds.
Factory reset Z-Wave Multisensor
1. Keep pressing the Button on the device for more than 5 seconds (the flash interval of the Status LED is now accelerated)
2. The device is now restored to factory settings
Note:
1, This procedure should only be used if the primary gateway is not capable of acting.
2, If the multi-sensor is set to the factory setting, the status is set to ""not included"", the association settings and possible configurations are reset to default.
Please note that this is a user manual Z-Wave Multisensor from ABUS is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Multisensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.