Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

Z-Wave RF Module including Antenna (PLAC90210) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Z-Wave RF Module including Antenna (PLAC90210)from ABUS. To view other Z-Wave products and manuals from ABUS follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Z-Wave RF Module including Antenna
SKU Code
PLAC90210
Description
The Nexello Z-Wave RF Module is a Bridge Controller to be used with different Gateways e.g. the Nexello Security System. Connected to the Nexello via 6-PIN UART interface, the Nexello Z-Wave RF-Module transmits data gathered from included Z-Wave devices to the Nexello. The module comes with a ceramic onboard antenna.
Version #
HW: 0 FW: ERROR was the version certified
Certification #
ZC10-20086963
Certified
2020-08-18T11:40:33.239115
Z-Wave Version
6.81.06

Security

As a Z-Wave Plus certified product, Z-Wave RF Module including Antenna supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    ABUS describes Z-Wave RF Module including Antenna as having the following features:

    • Communications Protocol
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    Factory reset Z-Wave RF Module including Antenna

    (The Reset Function is performed via the App-Client "Nexello")
    it can be accessed like this:
    Click on the settings button and follow the settings directory --> server settings --> Z-Wave configurations
    Click on the button "Network Reset"
    This function will reset the Z-Wave Module and delete all included Z-Wave devices. Once this function is performed, the Z-Wave devices will also no longer be visible in the App.
    Please keep in mind that the reset of the Z-Wave Network will result in the nodes (Z-Wave components) still have the home ID of the gateway stored and must be reset before they can be included again. This function should only be used in event of inoperable network conditions or in case of Gateway factory reset.

    Please note that this is a user manual Z-Wave RF Module including Antenna from ABUS is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave RF Module including Antenna and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.