The following is an overview of the user manual for the Z-Wave product Z-Wave Wireless-Socket (SHHA10000)from ABUS. To view other Z-Wave products and manuals from ABUS follow that link.
Overview
Security
As a Z-Wave Plus certified product, Z-Wave Wireless-Socket supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
ABUS describes Z-Wave Wireless-Socket as having the following features:
- Supported Meter Type
- Switch Type
- Firmware updatable via a compatible Z-Wave gateway
- Z-Wave Scene Type
- Switch Load Capacity Watts
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
A.) Plug the Wireless-Socket into an outlet. The Status-LED is flashing.
B.) Click the + (Add) button in your Z-Wave App and follow the further instructions
C.) Press the Network-Button on the Socket once. The App will show if the Add device process was successful. The Status LED does not flash anymore but indicates if device is switched on or off. Repeat the inclusion process from step B if it was not successful.
A.) Click the - (Remove) button in your Z-Wave App and follow the further instructions.
B.) Press the Button on the socket 3 times. The App will show if the Remove Device process was successful. The Status-LED will now flash continuously. Repeat the exclusion process from step A if it was not successful.
Factory reset Z-Wave Wireless-Socket
1. Keep pressing the Button on the socket for more than 5 seconds (the flash interval of the Status LED is now accelerated)
2. The wireless socket is now restored to factory settings
Note:
1, This procedure should only be used if the primary gateway is not capable of acting.
2, If the multi-sensor is set to the factory setting, the status is set to ""not included"", the association settings and possible configurations are reset to default.
Please note that this is a user manual Z-Wave Wireless-Socket from ABUS is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Wireless-Socket and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.