The following is an overview of the user manual for the Z-Wave product Home Automation and Control Unit (PGZNG1-2ADNAS)from ADT. To view other Z-Wave products and manuals from ADT follow that link.
Overview
innovative services gateway providing connectivity
to security systems, Wi-Fi devices (including
cameras and touch screens) and Z-Wave® devices
(including sensors, lighting controls, thermostats,
door locks, etc.).
Security
As a Z-Wave Plus certified product, Home Automation and Control Unit supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Access Control
- S2 Authenticated
- S2 Unauthenticated
Features
ADT describes Home Automation and Control Unit as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Gateway Has Preferred Partners
- Supported Notification Types
- Color
- Sensors
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Whether you can add devices to your site depends on the type of system and service you have as well as whether you are the site owner. If you are authorized to add devices, a Manage Devices button appears on the Web Portal's System tab.
If the Manage Devices button does appear on the System tab, use the following procedure to add devices.
To add a device to the site:
Log in to the Web Portal.
Click the System tab, if it is not already displayed.
Click Manage Devices.
Click the type of device you want to install and follow the on-screen instructions.
If you are authorized to reset a Z-Wave device, a Manage Devices button appears on the System tab. (Resetting or deleting a Z-Wave device both result in removing the Z-Wave device from the site.)
To delete or reset a Z-Wave device:
Click the System tab, if it is not already displayed.
Click Manage Devices.
The Manage Devices page appears.
Click Switches, Doors, Thermostats, Others.
The Z-Wave Devices page appears.
Click Reset.
The Reset Z-Wave Devices page appears.
Quickly press the ""include"" button on the device that you want to reset.
A message informs you that the device was successfully reset, and, in addition, the Z-Wave device is removed from the site. Once reset, you can add the Z-Wave device again to the same site or add it to another site.
Factory reset Home Automation and Control Unit
To reset the device, press and hold the reset button on the back of the unit for about 15 seconds. The unit will then restart.
Please note that this is a user manual Home Automation and Control Unit from ADT is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Home Automation and Control Unit and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.