The following is an overview of the user manual for the Z-Wave product PowerMaster-360 (PM-360)from ADT Security Services Inc.. To view other Z-Wave products and manuals from ADT follow that link.
Overview
Security
As a Z-Wave Plus certified product, PowerMaster-360 supports Z-Wave S2 security. The following security modes are directly supported:
Features
ADT describes PowerMaster-360 as having the following features:
- Communications Connections
- Communications Protocol
- Firmware updatable via a compatible Z-Wave gateway
- Outdoor Use
- Color
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Log in to your Amdocs Connected Home account (via web portal) and start the inclusion wizard (""Add a new device"" button). Select the icon that corresponds to the device to be included, or the generic Z-Wave icon (which works for all Z-Wave devices). Follow the instructions displayed by the inclusion wizard.
Log in to your Amdocs Connected Home account (via web portal) and go the Devices section (by clicking on the Devices tab). Find the device that needs to be excluded in the list of included devices. Click on the cross mark at the end of the line; this starts the exclusion wizard. Follow the instructions and perform the exclusion procedure on the Z-Wave device when instructed by the exclusion wizard.
Factory reset PowerMaster-360
Log in to your Amdocs Connected Home account (via web portal) and go the Devices section (by clicking on the Devices tab). Scroll down to the bottom of the page and expand the Advanced Settings section (collapsed by default). Click on the ""Reset Network Controller"" button.
Log in to your Amdocs Connected Home account (via web portal) and go the Devices section (by clicking on the Devices tab). Scroll down to the bottom of the page and expand the Advanced Settings section (collapsed by default). Put the other Z-Wave controller in Inclusion Mode and then click on the ""Enter Z-Wave Learn Mode"" button.
Please note that this is a user manual PowerMaster-360 from ADT Security Services Inc. is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have PowerMaster-360 and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.