Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

Z-Wave Garage Door Controller (GD00Z-6) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Z-Wave Garage Door Controller (GD00Z-6)from ADT. To view other Z-Wave products and manuals from ADT follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Z-Wave Garage Door Controller
SKU Code
GD00Z-6
Description
The GoControl GD00Z-6 is the next iteration of the best selling line of Z-Wave controlled remote garage door status indicator and activator. Adding S2 security and OTA capability, the GD00Z-6 continues to Nortek’s leadership positing in the IOT market. Open or close a sectional garage door remotely through a Z-Wave certified Gateway or Security Panel. Compatible with virtually any garage door opener connected to a sectional garage door. Audible and visual warnings prior to remotely-activated door movement, meeting UL 325 safety requirements. Included tilt sensor reports door "open" or "close" information.
Version #
HW: 3 FW: 3.00:03.00 was the version certified
Certification #
ZC10-18066150
Certified
2018-06-05T06:23:00.063896
Z-Wave Version
6.71.00

Security

As a Z-Wave Plus certified product, Z-Wave Garage Door Controller supports Z-Wave S2 security. The following security modes are directly supported:

  • S2 Access Control

Features

ADT describes Z-Wave Garage Door Controller as having the following features:

  • Color
  • Firmware updatable via a compatible Z-Wave gateway
  • Supported Notification Types
  • FLiRS capable
  • Supports Network Wide Inclusion
  • Supports Z-Wave Explorer Frames
  • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

Installation instructions

1. Place your Z-Wave Controller into Include mode.
2. Press and release the link button on the GD00Z-6.

1. Place your Z-Wave Controller into Exclude mode.
2. Press and release the link button on the GD00Z-6.

Factory reset Z-Wave Garage Door Controller

Reset the GD00Z-6 by pressing the LINK button 5 times. A quick beep followed by a longer beep will indicate the reset.
Reset should only be used in the case of a missing or inoperative primary controller.

Please note that this is a user manual Z-Wave Garage Door Controller from ADT is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Garage Door Controller and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.