The following is an overview of the user manual for the Z-Wave product 4-in-1 Motion Sensor (HA-ZW-5SABC)from Aibase. To view other Z-Wave products and manuals from Aibase follow that link.
Overview
Security
As a Z-Wave Plus certified product, 4-in-1 Motion Sensor supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
Aibase describes 4-in-1 Motion Sensor as having the following features:
- Battery powered using CR123A batteries
- Sensors
- Firmware updatable via a compatible Z-Wave gateway
- Supported Notification Types
- Battery Quantity
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Add 4-in-1 Motion Sensor into a Z-Wave network:
a. Let the primary controller go into inclusion mode (If you don’t know how to do this, refer to its manual).
b. Short Press one time this Z-Button.
c. The 4-in-1 Motion Sensor LED will blink, If the inclusion is successful, then LED will keep on 2 seconds. Otherwise, the LED will blink until timeout, in which case you need to repeat the process from step b.
Remove 4-in-1 Motion Sensor from a Z-Wave network:
a. Let the primary controller go into exclusion mode (If you don’t know how to do this, refer to its manual).
b. Short Press one time this Z-Button.
c. The 4-in-1 Motion Sensor LED will keep on, If the remove is successful, then LED will blink 2 seconds. Otherwise, the LED will keep on until timeout, in which case you need to repeat the process from step b.
Note: 4-in-1 Motion Sensor will go away “Z-Wave SmartStart” Inclusion when it is removed from a Z-Wave network.
Factory reset 4-in-1 Motion Sensor
Reset 4-in-1 Motion Sensor to factory Default:
1. Press and hold the Z-Button for 5 seconds.
2. If holding time is more than 5 seconds, the LED will blink fast at acceleration. If reset success 4-in-1 Motion Sensor LED will turn off. When the Z-Button is released, it will send “Device Reset Locally Command”. Otherwise please repeat step 2.
Note:
1, This procedure should only be used when the primary controller is inoperable.
2, Reset 4-in-1 Motion Sensor to factory default settings. It will set the 4-in-1 Motion Sensor to not in Z-Wave network state; delete the Association setting and restore the Configuration setting to the default.
Please note that this is a user manual 4-in-1 Motion Sensor from Aibase is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have 4-in-1 Motion Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.