The following is an overview of the user manual for the Z-Wave product A19 Led Bulb Rgbw (HA-ZW-5AQG)from Aibase. To view other Z-Wave products and manuals from Aibase follow that link.
Overview
RGBW Bulb has 5 main color channels available for you to adjust: Warm white , Cold white,Red,Green and Blue. RGBW Bulb can be included and operated in any Z‐Wave network with other Z‐Wave certifieddevices from other manufacturers and/or other applications. All non‐battery operated nodes within the network will act as repeaters regardless of vendor to increase reliability of the network.
The RGBW Bulb is a security Z-Wave device(S0), so a security enabled controller is needed for take full advantage of all functionally for the LED Bulb. It also supports the Over The Air (OTA) feature for the product’s firmware upgrade.
Security
As a Z-Wave Plus certified product, A19 Led Bulb Rgbw supports Z-Wave S2 security. The following security modes are directly supported:
Features
Aibase describes A19 Led Bulb Rgbw as having the following features:
- Communications Protocol
- Firmware updatable via a compatible Z-Wave gateway
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Add for inclusion:
a) Set the Z-Wave network main controller into adding mode.
b) Power cycle once for the led bulb(OFF->ON).The led bulb will flash once when it has been include into the network.
Remove for exclusion：
a) Set the Z-Wave network main controller into removing mode.
b) Power cycle once for the led bulb(OFF->ON).Then the led bulb will flash once then dim to 5%,when it has been excluded outside the network.
Factory reset A19 Led Bulb Rgbw
Reset the device :
Led bulb re-power 6 times (between 0.5-2 seconds each time); If the 6th power on, the led bulb flashes twice (first time: red to green to blue gradient transition, second time: 2700K), which means that the resetting is successful.
NOTE:
Using this action in case of the primary controller is missing or inoperable.
Please note that this is a user manual A19 Led Bulb Rgbw from Aibase is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have A19 Led Bulb Rgbw and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.