The following is an overview of the user manual for the Z-Wave product Water Leak Sensor (HA-ZW-5SF)from Aibase. To view other Z-Wave products and manuals from Aibase follow that link.
Overview
✓ Low voltage alarm to remind changing battery
✓ Easy to set up and use
✓ Universally applicable: universally applicable in every place and circumstances.
Security
As a Z-Wave Plus certified product, Water Leak Sensor supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
Aibase describes Water Leak Sensor as having the following features:
- Battery Quantity
- Supported Notification Types
- Battery powered using CR batteries
- Firmware updatable via a compatible Z-Wave gateway
- Sensors
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset Water Leak Sensor
Pressing and holding the z-button for 5 seconds, LED will blink for 5 seconds and then keep solid for 3 seconds, after that Water Leak Sensor will send “Device_Reset_Locally” to the main controller and exclude from the Z-Wave network.
Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.
1. Insert the battery.
2. Set the Z-Wave network main controller into Inclusion mode.
3. Triggering this button action.
4. If the add for inclusion is successful, the LED will blink fast and then keep on 3 seconds. Otherwise, the LED will blink 25 seconds and then turn off, in which case you need to repeat the process from step 2.
1. Insert the battery.
2. Set the Z-Wave network main controller into exclusion mode.
3. Triggering this button action.
If the remove for exclusion is successful, the LED will blink fast and turn off. Otherwise, the LED will keep solid for 25 seconds and then turn off, in which case you need to repeat the process from step 2.
Short press the z-button 3 times within 1 second.
LED will blink once, and Sensor will send wake up notification to wake the device up.
Please note that this is a user manual Water Leak Sensor from Aibase is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Water Leak Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.