Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

Smart Thermostat (ADC-T3000) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Smart Thermostat (ADC-T3000)from Alarm.com. To view other Z-Wave products and manuals from Alarm.com follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Smart Thermostat
SKU Code
ADC-T3000
Description
The Alarm.com Intelligent Thermostat gives you remote access and control of your thermostat. Enjoy effortless energy management, climate and ambiance control, custom automation and measurable results. Create custom smart schedules that automate your thermostat. Receive critical temperature alerts to know instantly when your thermostat reaches preset limits. Save energy by using location-based automation to have your thermostat adjust itself while you're out.

This thermostat is part of an entire ecosystem of home automation products. It was built to provide a single integrated solution to give you more from your connected home.
Version #
HW: 8 FW: 1.20:01.20:01.20 was the version certified
Certification #
ZC10-19076575
Certified
2019-07-01T14:05:34.72273
Z-Wave Version
6.81.03

Security

As a Z-Wave Plus certified product, Smart Thermostat supports Z-Wave S2 security. The following security modes are directly supported:

  • S2 Authenticated
  • S2 Unauthenticated

Features

Alarm.com describes Smart Thermostat as having the following features:

  • Battery Quantity
  • Thermostat HVAC Systems Supported
  • Thermostat Modes
  • Battery powered using AAA batteries
  • Gateway Has Preferred Partners
  • Color
  • Firmware updatable via a compatible Z-Wave gateway
  • Sensors
  • Supported Notification Types
  • Thermostat Power Source
  • FLiRS capable
  • Supports Network Wide Inclusion
  • Supports Z-Wave Explorer Frames
  • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

Installation instructions

1. Put Z-Wave controller into Remove mode. See Z-Wave controller documentation for further documentation.
2. Press the Menu (-) Button
3. Select SETTINGS
4. Select NETWORK
5. Select REMOVE
6. Thermostat will display ‘Network Remove In Progress’.
7. The thermostat has been removed successfully when the thermostat displays ‘Network Remove Complete’

Factory reset Smart Thermostat

Please use this procedure only when the network primary controller is missing or otherwise inoperable.

1. Turn the display on with any button press
2. Press Menu (-) button to go to main menu
3. Select SETTTINGS.
4. Select CONTINUE when prompted with the warning.
5. Select RESET
6. Select YES when prompted with the reset confirmation question.
7. Select CONTINUE when prompted with the network reset question.

1. Put Z-Wave controller into Add mode. See Z-Wave controller documentation for further documentation.
2. Press the Menu (-) Button
3. Select SETTINGS
4. Select NETWORK
5. Select ADD
6. Thermostat will display ‘Network Add In Progress’ and the 4-digit DSK pin. The pin can be used for S2 inclusion.
7. The thermostat has been added successfully when the thermostat displays ‘Network Add Complete’

Please note that this is a user manual Smart Thermostat from Alarm.com is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Smart Thermostat and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.