The following is an overview of the user manual for the Z-Wave product Smart Water Valve (ADC-SWV100)from Alarm.com. To view other Z-Wave products and manuals from Alarm.com follow that link.
Overview
Security
As a Z-Wave Plus certified product, Smart Water Valve supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Alarm.com describes Smart Water Valve as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Color
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1) Put Z-Wave controller into Add mode. See Z-Wave controller documentation for further information.
2) Press the NETWORKING button on the side of the control unit. The Z-Wave LED will begin to blink.
3) The valve has been successfully added to the network when the Z-Wave LED becomes solid.
1) Put Z-Wave controller into Remove mode. See Z-Wave controller documentation for further documentation.
2) Press the NETWORKING button on the side of the control unit. The Z-Wave LED will begin to blink.
3) The valve has been successfully removed from the network when the Z-Wave LED is no longer flashing or illuminated.
Factory reset Smart Water Valve
NOTE: Device reset will reset EEPROM, configuration parameters, Z-Wave chip and forcibly clear the Smart Water Valve’s Z-Wave Node Identification. Please use this procedure only when the network primary controller is missing or otherwise inoperable.
1) Press and hold the NETWORKING button on the side of the control unit 5 seconds. The LEDs will blink rapidly for 5 seconds.
2) If there are nodes in the “Lifeline” association group, the LEDs will blink slower until all nodes are notified using a Device Reset Locally Report.
3) Once the device has been reset, the LEDs will return to their normal state.
Please note that this is a user manual Smart Water Valve from Alarm.com is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Smart Water Valve and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.