The following is an overview of the user manual for the Z-Wave product Digital Mortise Door Lock (ML2)from Alfred. To view other Z-Wave products and manuals from Alfred follow that link.
Overview
Security
As a Z-Wave Plus certified product, Digital Mortise Door Lock supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Access Control
Features
Alfred describes Digital Mortise Door Lock as having the following features:
- Battery powered using KDAPAD2 batteries
- Firmware updatable via a compatible Z-Wave gateway
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: Section 3.7 in ML2 Advanced Information Product Manual
1. Follow the user guide of hub to enter inclusion mode.
2. Operate on lock following guide below:
1) Enter master mode(** + Master PIN Code + √)
2) Input “8” to enter “function extension settings”
3) Input “1” to enter “Inclusion mode”
1. Follow the user guide of hub to enter exclusion mode.
2. Operate on lock following guide below:
1) Enter master mode(** + Master PIN Code + √)
2) Input “8” to enter “function extension settings”
3) Input “2” to enter “Exclusion mode”
Factory reset Digital Mortise Door Lock
1. Operations on lock
1) Open the door and keep the lock in "unlock" status
2) Open battery box and find the reset button.
3) Use a sharp thing to press and hold the reset button.
4) Keep holding the reset button and remove the battery from battery box then replace it.
5) Keep holding the reset button down until you hear the lock beep (Can take up to 10 seconds).
2. Please use this procedure only when the network primary controller is missing or otherwise inoperable.
The Device Role Types is Listening Sleeping Slave (LSS).
Please note that this is a user manual Digital Mortise Door Lock from Alfred is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Digital Mortise Door Lock and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.