The following is an overview of the user manual for the Z-Wave product Touchscreen Digital Deadbolt (DB2)from Alfred. To view other Z-Wave products and manuals from Alfred follow that link.
Overview
Security
As a Z-Wave Plus certified product, Touchscreen Digital Deadbolt supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Access Control
Features
Alfred describes Touchscreen Digital Deadbolt as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Supported Notification Types
- Battery powered using AA alkaline batteries
- Battery Quantity
- Door Lock Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset Touchscreen Digital Deadbolt
※Please use this procedure only when the network primary controller is missing or inoperable.
-Operations on lock
1.Open the door and keep the lock in ""unlock"" status
2.Open battery box and find the reset button.
3.Use a sharp thing to press and hold the reset button.
4.Keep holding the reset button and remove a battery from battery box then replace it.
5.Keep holding the reset button until hearing voice guide.
-Follow the user guide of hub to enter inclusion mode.
-Operate on lock following guide below:
1.Enter master mode(refer to programming instruction)
2.Input “8” to enter “function extension settings”
3.Input “1” to join a network.
-Follow the user guide of hub to enter exclusion mode.
-Operate on lock following guide below:
1.Enter master mode(refer to programming instruction)
2.Input “8” to enter “function extension settings”
3.Input “2” to log off a network.
Please note that this is a user manual Touchscreen Digital Deadbolt from Alfred is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Touchscreen Digital Deadbolt and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.