The following is an overview of the user manual for the Z-Wave product Smart Lock (ADSL-1001)from AMADAS. To view other Z-Wave products and manuals from AMADAS follow that link.
Overview
● AMADAS Smart Lock offers D.I.Y. installation. There is no need to call a professional installer. Users can install it by themselves without any professional technique. Also, it works for 100% of the time even when the batteries run out. AMADAS can be powered by shining a smart phone flash light on the built-in solar panel for 20 seconds.
● AMADAS Smart Lock connects to user's smartphone. For better security, users can check door lock condition, access log, etc., via its unique app whenever or wherever they are.
● With its high compatibility, AMADAS Smart Lock can be installed on the most comprehensive standard doors regardless of a thickness, material and in/outdoor.
● Made for both tech-savvy and non tech-savvy users, they can easily enter their homes via Smartphone or the button (Touch/Push) configuration on AMADAS' lever, whichever way is most convenient.
Security
As a Z-Wave Plus certified product, Smart Lock supports Z-Wave S2 security. The following security modes are directly supported:
Features
AMADAS describes Smart Lock as having the following features:
- Door Lock Type
- Sensors
- Battery Quantity
- Firmware updatable via a compatible Z-Wave gateway
- Outdoor Use
- Battery powered using LR06 AA batteries
- Color
- Supported Notification Types
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
- Z-Wave inclusion:
i. Press “Z-Wave Settings” button in the inner side for 3 seconds. (toggle status)
ii. Then “Blue LED” will turn on.
iii. When the inclusion is complete, the led is turned off and the beep sounds. Please wait.
* Beep : Success (Beep), Fail (Beep~)
* The inclusion results can be found in the controller or in your app.
- Z-Wave exclusion
i. Press “Z-Wave Settings” button in the inner side for 3 seconds. (toggle status)
ii. Then “Blue LED” will turn on.
iii. When the exclusion is completed, the led is turned off and the beep sounds. Please wait.
* Beep : Success (Beep Beep), Fail (Beep~)
* The exclusion results can be found in the controller or in your app.
Factory reset Smart Lock
1. Factory default setting
i. Press “Settings, Input” button in the inner side for 3 seconds.
ii. Press “④ - Reset” button in the outer side.
iii. Enter “1004” and press the “*” button.
2. Z-Wave device reset locally
i. Press “Z-Wave Settings” button in the inner side 3 times within 1.5 seconds.
ii. Then “White LED” will turn on.
iii. When the “network reset locally” is complete, the led is turned off. Please wait.
* Beep : Success (Ring), Fail (Beep~)
* Z-Wave network information is initialized.
* Please use this procedure only when the network primary controller is missing or otherwise inoperable.
- Through the Z-Wave network generates an order, the product
will receive the wakeup call and starts to operate.
- The product will receive the wakeup call when the buttons on
the outer lever are touched (pushed) to open the door.
- The product will receive the wakeup call when the buttons on
the inner lever are pushed.
Please note that this is a user manual Smart Lock from AMADAS is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Smart Lock and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.