Door Contact (ZD2102EU-5) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Door Contact (ZD2102EU-5)from Anchor. To view other Z-Wave products and manuals from Anchor follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions


Door Contact
SKU Code
The ZD2102-5 Door and Window sensor is used in any Z-Wave network to detect the opening or closing of a door or window. Special Design can fit most of door/window frame. The primary sensing element is a magnetic reed switch, the ZD2102-5 is supplied with the sensor, sensor mounting bracket and the trigger magnet. An additional set of sensor inputs are provided through a 2 position screw terminal and can be used to expand the sensor capability to multiple inputs. The ZD2102-5 is powered by a single CR123A Lithium Battery (supplied with unit, battery life is more than 5 years) and is intended for indoor use only. The ZD2102-5 features tamper proof switch, low battery warning and can be firmware updated over the air.
Version #
HW: 2 FW: 5.01:10.02 was the version certified
Certification #
Z-Wave Version


As a Z-Wave Plus certified product, Door Contact supports Z-Wave S2 security. The following security modes are directly supported:


    Anchor describes Door Contact as having the following features:

    • Supported Notification Types
    • Battery Quantity
    • Battery powered using CR123A batteries
    • Color
    • Communications Protocol
    • Firmware updatable via a compatible Z-Wave gateway
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    For “Inclusion” (adding to) a network: Put the Z-Wave™ network controller into “inclusion” mode following its instructions. To add the ZD2102-5 to your controller press the program switch of ZD2102-5 to send the Node Information Frame (NIF). After sending NIF, the network controller will send the auto inclusion request; otherwise, ZD2102-5 will go to sleep after 15 seconds.

    For “Exclusion” (removing from) a network: Put the Z-Wave™ network controller into “exclusion” mode, following its instructions. To delete the ZD2102-5 from your controller press the program switch of ZD2102-5 for at least 1 second to be excluded. Note: All user and network settings will be cleared and the device reset to factory setting defaults when the device is excluded.

    PowerLevel Control, Battery Votlage Detection(Auto report low battery),OTA function

    Factory reset Door Contact

    Factory Default Reset: Trigger the rear cover switch to send the Alarm Report and trigger the reed switch (close & open) 5 times in 10 seconds, ZD2102-5 will send the “Device Reset Locally Notification” command and reset to the factory default condition. Please use this procedure only when the network primary controller is missing or otherwise inoperable.

    The ZD2102-5 is forced awake by opening the rear cover, the red LED will stay on and the 2102-5 will stay awake for 10 seconds. The ZD2102-5 will send “Wake Up Notification”. If ZD2102-5 receives a “Wake Up No More Information” command then the red LED will go off and it will go to sleep.
    Auto Wake Up: The wakeup interval is user settable from 10 minutes to 1 week using COMMAND_CLASS_WAKE_UP, Interval increment is 3 minutes.

    Please note that this is a user manual Door Contact from Anchor is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. only warrants and is only able to support products purchased directly from us. If you have Door Contact and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.