The following is an overview of the user manual for the Z-Wave product VeriLock Translator (9125051)from Andersen. To view other Z-Wave products and manuals from Andersen follow that link.
Overview
These sensors are added to the VeriLock Translator™ as Multi Channel End Points. Because the number of sensors in a home is dynamic, the number of End Points on the device is also dynamic. Unlike the VeriLock Translator™, the sensors are NEVER represented as nodes on the Z-Wave network and cannot communicate over the Z-Wave network. Their status, however, is reported by the VeriLock Translator™ over the Z-Wave network via the Multi Channel Command Class.
The VeriLock Translator™ is added to the Z-Wave network as a Repeater and implements the Routing Slave library. The VeriLock Translator™ is a Z-Wave Plus certified device.
Security
As a Z-Wave Plus certified product, VeriLock Translator supports Z-Wave S2 security. The following security modes are directly supported:
Features
Andersen describes VeriLock Translator as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
If not included to a Z-Wave network, the device will attempt to be added to the network at power-up following an LED start-up sequence. The controller must be put into include mode before plugging in the device.
During normal operation, after putting the controller into include mode, a single press of the round Z-Wave button will add the device to the Z-Wave network.
After putting the controller in exclude mode, a single press of the round Z-Wave button will remove the device from the Z-Wave network.
Factory reset VeriLock Translator
The device is factory reset by pressing and holding both the round (Z-Wave) and square (Multi-Purpose) buttons simultaneously for 15 seconds. Please use this procedure only in emergencies such as when the network primary controller is missing or otherwise inoperable. This should always be used as a last resort.
Please note that this is a user manual VeriLock Translator from Andersen is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have VeriLock Translator and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.