The following is an overview of the user manual for the Z-Wave product Moving Blinds Art Andersen (1.0)from Art Andersen CPH. To view other Z-Wave products and manuals from Art Andersen CPH follow that link.
Overview
Security
As a Z-Wave Plus certified product, Moving Blinds Art Andersen supports Z-Wave S2 security. The following security modes are directly supported:
Features
Art Andersen CPH describes Moving Blinds Art Andersen as having the following features:
- Window Covering Control Features
- Battery Quantity
- Battery powered using Li-ion batteries
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Pressing and holding both buttons for 1 to 5 seconds.
Pressing and holding both buttons for 5 to 10 seconds when the Moving blind is in the top position.
Factory reset Moving Blinds Art Andersen
Pressing both buttons for more than 30 seconds when the Moving blind is anywhere but in the bottom position. WARNING, don’t do this unless you are very sure what you are doing. Please use this procedure only when the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual Moving Blinds Art Andersen from Art Andersen CPH is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Moving Blinds Art Andersen and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.