The following is an overview of the user manual for the Z-Wave product Bl 900hw (H03HG4)from au. To view other Z-Wave products and manuals from au follow that link.
Overview
So this can be used only in KDDI's network.
This also has the following features
・Wireless router technology : IEEE 802.11a/b/g/n dual band.
・Number of USB Ports：USB2.0 × 1 port
・Number of Ether port : 1Gbps × 4port type RJ45
・Dial-up port ：1port type RJ11
When you use this device as the z-wave gateway, you have to subscribe the KDDI's FTTH service and plug the special dongle provided by KDDI to USB port.
Security
As a Z-Wave Plus certified product, Bl 900hw supports Z-Wave S2 security. The following security modes are directly supported:
Features
au describes Bl 900hw as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Sensors
- Gateway Has Preferred Partners
- Supported Notification Types
- Color
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
It is to select the kinds of device by Smartphone application, and it induces to push down the program switch of device.
It is select the registered device by Smartphone application, and it induces to push down the program switch of device.
Factory reset Bl 900hw
1.It is to pull out the power outlet on HOME Gateway, and wait for approximately 10 seconds.
2.It is to hold down the update button on back side ,and at the same time insert the power outlet.
After approximately 20 seconds it blinks 3 times at the same time on Update lump ,Network lump, Telephone lump, Wireless 1 lump, Wireless 2 lump, and Power lump, release your hands from the update button.
※Don't power off on HOME Gateway until completed initialize, because it is the cause of breakdown.
""If this controller is the primary controller for your network, resetting it will result in the nodes in your network being orphaned and it will be necessary after the reset to exclude and re-include all of the nodes in the network. If this controller is being used as a secondary controller in the network, use this procedure to reset this controller only in the event that the network primary controller is missing or otherwise inoperable.""
Please note that this is a user manual Bl 900hw from au is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Bl 900hw and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.