The following is an overview of the user manual for the Z-Wave product Alert Button (T8343-EUR)from Axis Communications . To view other Z-Wave products and manuals from Axis follow that link.
Overview
Security
As a Z-Wave Plus certified product, Alert Button supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Axis describes Alert Button as having the following features:
- Color
- Firmware updatable via a compatible Z-Wave gateway
- Battery Quantity
- Battery powered using AAA batteries
- Supported Notification Types
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
After the detector has been included into a Z-Wave network it will go to sleep, but it will send a wake-up notification command to
the controller periodically at a preset period . The detector will stay awake for at least 10 seconds and then go back to sleep to
conserve battery life.
Factory reset Alert Button
1. Press the link button 3 times within 1.5 seconds to put the device into exclusion mode.
2. Within 1 second of step 1, press the link button again and hold for 5 seconds.
3. Node ID is excluded. The device reverts to factory default state.
(This procedure should only be used when the controller is
inoperable.)
Manual exclusion
1. Detach the front cover.
2. Press the link button 3 times within 1.5 seconds to put the unit into learning (inclusion/exclusion) mode.
3. The exclusion process should be completed when the LED stops blinking.
4. Refit the front cover.
Auto inclusion
1. Carefully remove the front cover by pulling the bottom of the front cover.
2. Put a Z-Wave controller into inclusion mode.
3. Insert 2 AAA-batteries (1,5V) into the battery compartment with the correct polarity. The LED on the device should turn ON
4. Enter PIN number into the Z-Wave controller. The PIN number can be found on the device. See where in the installation
guide.
5. The inclusion process should be completed when the LED stops blinking
6. Perform test before you refit the battery cover. See How to test the Z-Wave Device.
Manual inclusion
1. Carefully remove the front cover by pulling the bottom of the front cover. There is a link button which is used to put the
device in learning mode (inclusion/exclusion).
2. Press the link button 3 times within 1.5 seconds to put the unit into learning (inclusion/exclusion) mode.
3. Enter PIN number into the Z-Wave controller. The PIN number can be found on the device. See where in the installation
guide.
4. The inclusion process should be completed when the LED stops blinking
5. Perform test before you refit the battery cover.
Please note that this is a user manual Alert Button from Axis Communications is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Alert Button and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.