The following is an overview of the user manual for the Z-Wave product PIR Motion Sensor (T8341-EUR)from Axis Communications . To view other Z-Wave products and manuals from Axis follow that link.
Overview
Security
As a Z-Wave Plus certified product, PIR Motion Sensor supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Axis describes PIR Motion Sensor as having the following features:
- Supported Notification Types
- Battery Quantity
- Battery powered using CR123A batteries
- Color
- Firmware updatable via a compatible Z-Wave gateway
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Manual exclusion
1. Use a screwdriver to detach the battery cover.
2. Press the tamper switch 3 times within 1.5 seconds to put the unit into learning (inclusion/exclusion) mode.
3. The exclusion process should be completed when the LED stops blinking
4. Refit the battery cover.
Factory reset PIR Motion Sensor
1. Press the tamper switch 3 times within 1.5 seconds to put the device into exclusion mode.
2. Within 1 second of step 1, press the tamper switch again and hold until LED is off (about 5 seconds).
3. Node ID is excluded. The device reverts to factory default state and will be in auto-inclusion mode for 4 minutes.
(This procedure should only be used when the controller is not
responding.)
After the detector has been included into a Z-Wave network it will go to sleep, but it will send a wake-up notification command
to the controller periodically at a preset period . The motion detector will stay awake for at least 10 seconds and then go back to
sleep to conserve battery life.
Auto inclusion
1. Use a screwdriver to detach the battery cover.
2. Put the AXIS M5065 camera (or other Z-Wave controller) into inclusion mode.
3. Insert 1 CR123 3V batteries into the battery compartment with the correct polarity. The LED on the device should turn ON
4. Enter PIN number into the Z-Wave controller. The PIN number can be found on the device. See where in the installation
guide.
5. The inclusion process should be completed when the LED stops blinking
6. Perform test before you refit the battery cover. See How to test the Z-Wave Device.
Manual inclusion
1. Use a screwdriver to detach the battery cover.
2. Put the AXIS M5065 camera (or other Z-Wave controller) into inclusion mode.
3. Insert 1 CR123 3V batteries into the battery compartment with the correct polarity. The LED on the device should turn ON
4. Press the tamper switch 3 times within 1.5 seconds to put the unit into learning (inclusion/exclusion) mode.
5. Enter PIN number into the Z-Wave controller. The PIN number can be found on the device. See where in the installation
guide.
6. The inclusion process should be completed when the LED stops blinking.
7. Perform test before you refit the battery cover. See How to test the Z-Wave Device.
Please note that this is a user manual PIR Motion Sensor from Axis Communications is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have PIR Motion Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.