The following is an overview of the user manual for the Z-Wave product Power On/Off Plug (T8344-JP)from Axis Communications . To view other Z-Wave products and manuals from Axis follow that link.
Overview
Security
As a Z-Wave Plus certified product, Power On/Off Plug supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Axis describes Power On/Off Plug as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Switch Load Capacity Current
- Switch Load Capacity Volt-Ampere
- Sensors
- Supported Notification Types
- Color
- Electric Load Type
- Switch Load Capacity Watts
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Manual exclusion
Note:
For more details see the installation guide
1. Put the Z-Wave controller in exclusion mode
2. Press the link button 3 times within 1.5 seconds to put the unit into learning (inclusion/exclusion) mode.
3. The process should be completed when the LED stops blinking
Auto inclusion
The detector supports the auto inclusion feature where it will automatically enter Inclusion mode when first powered up. This will also apply when powered up after a factory reset.
1. On the front side of the device, there is a link-button/LED-indicator which is used to set the device in learning mode
(inclusion, exclusion).
2. Put a Z-Wave controller into inclusion mode.
3. Plug the On/off Plug into a wall outlet near the device to be controlled.
4. The inclusion process should be completed when the LED stops blinking
Manual inclusion
If auto inclusion fails, you can choose to add the Z-Wave device to a control device. Please follow the steps described below.
Note:
For more details see the installation guide
1. Put the Z-Wave controller in inclusion mode
2. Press the link button 3 times within 1.5 seconds to put the unit into learning (inclusion/exclusion) mode.
3. The process should be completed when the LED stops blinking
Factory reset Power On/Off Plug
Factory Reset (This procedure should only be used when the controller is inoperable.)
1. Press the link button 3 times within 1.5 seconds to put the unit into exclusion mode.
2. Within 1 second of step 1, press and hold the button for 5 seconds.
3. Node ID is deleted. The device reverts to factory default state.
Please note that this is a user manual Power On/Off Plug from Axis Communications is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Power On/Off Plug and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.