The following is an overview of the user manual for the Z-Wave product Dual Relay (B1DR01-ZW-IN)from B.One. To view other Z-Wave products and manuals from B.One follow that link.
Overview
You can use it to control your home light or bulbs on/off.
It can connect to 2 external manual switches to control the load ON/OFF independently. Its surface has a pin socket, which can be used for connecting to the touch panel, so you can also use the touch panel to control the Dual Relay Switch.
It can also be included and operated in any Z-Wave network with other Z-Wave certified devices from other manufacturers and/or other applications. All non-battery operated nodes within the network will act as repeaters regardless of vendor to increase reliability of the network.
It is a security Z-Wave plus device, so a security enabled controller is needed for take full advantage of all functionally for the Relay Switch. It also supports the Over The Air (OTA) feature for the product’s firmware upgrade.
As soon as Dual Relay is removed from a Z-Wave network it will be restored into default factory setting.
Security
As a Z-Wave Plus certified product, Dual Relay supports Z-Wave S2 security. The following security modes are directly supported:
Features
B.One describes Dual Relay as having the following features:
- Switch Type
- Z-Wave Scene Type
- Electric Load Type
- Firmware updatable via a compatible Z-Wave gateway
- Supported Notification Types
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Turn the primary controller of Z-Wave network into inclusion mode, short press the product’s Action button that you can find on the product's housing.
Turn the primary controller of Z-Wave network into exclusion mode, short press the product’s Action button that you can find on the product's housing.
Factory reset Dual Relay
Press and hold the Action button that you can find on the product's housing for 20 seconds and then release. This procedure should only be used when the primary controller is inoperable.
Support ""Over the Air Firmware Updating"" and “Z-Wave Security”.
Please note that this is a user manual Dual Relay from B.One is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Dual Relay and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.