The following is an overview of the user manual for the Z-Wave product Motion Sensor (B1MS02-ZW-IN)from B.One. To view other Z-Wave products and manuals from B.One follow that link.
Overview
The features list:
1) Z-Wave Plus certified for wide compatibility (500 serials product).
2) Supports security 0 and security 2 protected mode with AES-128 encryption.
3) Motion sensor.
4) Tamper alarm by shock sensor.
5) The battery life is up to 1 year.
6) Low battery alarm.
7) Support firmware OTA.
Security
As a Z-Wave Plus certified product, Motion Sensor supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
B.One describes Motion Sensor as having the following features:
- Battery powered using CR123A batteries
- Sensors
- Color
- Supported Notification Types
- Battery Quantity
- Firmware updatable via a compatible Z-Wave gateway
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Triple click the Z-button quickly，and then the dut will enter into the Learn Mode.
1) Open the cover.
2) Place the device within the direct range of your Z-Wave controller.
3) Set the main controller in add mode (see the controller’s manual).
4) Click the Z-button once or triple click the Z-button quickly, the LED indicator should blink fast.
5) Wait for the adding process to end.
6) Successful adding will be confirmed by the Z-Wave controller’s message.
1) Open the cover.
2) Place the device within the direct range of your Z-Wave controller.
3) Set the main controller remove mode (see the controller’s manual).
4) Triple click the Z-button quickly, the LED indicator should blink fast.
5) Wait for the removing process to end.
6) Successful adding will be confirmed by the Z-Wave controller’s message.
Press and hold the Z button for more than 5 seconds and release.
Factory reset Motion Sensor
1)Power on the device,
2) Press and hold the Z button for more than 20 seconds,
3) If holding time more than 20seconds, the LED indicator will keep on for 2 seconds, which means resetting is complete.
4) The reset feature works only when the device has been included into a Z-Wave network.
Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual Motion Sensor from B.One is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Motion Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.