The following is an overview of the user manual for the Z-Wave product Smart Dimmer (B1SD01-ZW-IN)from B.One. To view other Z-Wave products and manuals from B.One follow that link.
Overview
You can use it to control (on/off/dim) of any kinds of bulbs. It supports a variety of installations of wiring connection, such as the 2-wire, 3-wire connection and so on.
It can be included and operated in any Z-Wave network with other Z-Wave certified devices from other manufacturers and/or other applications. All non-battery operated nodes within the network will act as repeaters regardless of vendor to increase reliability of the network.
The B.One Smart Dimmer is a security Z-Wave plus device, so a security enabled controller is needed for take full advantage of all functionally for the Dimmer. It also supports the Over The Air (OTA) feature for the product’s firmware upgrade.
As soon as B.One Smart Dimmer is removed from a Z-Wave network, it will be restored into default factory setting.
Security
As a Z-Wave Plus certified product, Smart Dimmer supports Z-Wave S2 security. The following security modes are directly supported:
Features
B.One describes Smart Dimmer as having the following features:
- Neutral Wire Required
- Supported Meter Type
- Firmware updatable via a compatible Z-Wave gateway
- Electric Load Type
- Supported Notification Types
- Switch Type
- Z-Wave Scene Type
- Color
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Turn the primary controller of Z-Wave network into inclusion mode, short press the product’s Action button that you can find on the product's housing.
Turn the primary controller of Z-Wave network into exclusion mode, short press the product’s Action button that you can find on the product's housing.
Factory reset Smart Dimmer
Press and hold the Action button that you can find on the product's housing for 20 seconds and then release. This procedure should only be used when the primary controller is missing or inoperable.
Support ""Over the Air Firmware Updating"" and “Z-Wave Security”.
Please note that this is a user manual Smart Dimmer from B.One is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Smart Dimmer and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.