The following is an overview of the user manual for the Z-Wave product Smart Sensor (B1SS02-ZW-AU)from B.One. To view other Z-Wave products and manuals from B.One follow that link.
Overview
Security
As a Z-Wave Plus certified product, Smart Sensor supports Z-Wave S2 security. The following security modes are directly supported:
Features
B.One describes Smart Sensor as having the following features:
- Battery Quantity
- Supported Notification Types
- Battery powered using AAA batteries
- Sensors
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Insert the AAA battery.
2. Set the Z-Wave network main controller into learning mode.
3. Triple or single short press the Z-button.
4. If the add for inclusion is successful, the LED will blink less than 5 seconds and then keep on 3 seconds. Otherwise, the LED will blink 5 seconds and then turn off, in which case you need to repeat the process from step 2.
1. Insert the AAA battery.
2. Set the Z-Wave network main controller into learning mode.
3. Triple clicking the Z-button.
4. If the remove for exclusion, the LED will turn off within 1 second. Otherwise, the LED will blink 5 seconds and then turn off, in which case you need to repeat the process from step 2.
Factory reset Smart Sensor
1. Insert the AAA battery.
2. Pressing and holding the Z button for more than 20 seconds,
3. Led will keep on until the Z-Button is released, and it will reset to factory default when the button is released.
Using this procedure only in the event that the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual Smart Sensor from B.One is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Smart Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.