The following is an overview of the user manual for the Z-Wave product Multi-Channel Remote Control (MCZ1)from Bali. To view other Z-Wave products and manuals from Bali follow that link.
Overview
Security
As a Z-Wave Plus certified product, Multi-Channel Remote Control supports Z-Wave S2 security. The following security modes are directly supported:
Features
Bali describes Multi-Channel Remote Control as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Switch Load Capacity Watts
- Switch Type
- Window Covering Control Features
- Switch Load Capacity Current
- Z-Wave Scene Type
- Battery powered using AAA Battery batteries
- Color
- Battery Quantity
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Adding your shades and remotes to the same “shade network” (a group of shades and remotes that communicate with each
other) or to a home automation system.
1. Press and hold the MENU/RIGHT button
for 2 seconds to enter the menu.
2. Select ZWAVE > INCLUDE.
3. On the shade you want to pair,
press and hold the program button for
3 seconds. When the shade LED flashes
green, release the button.
The remote’s screen will indicate
Removing the current pairing between your shades and remotes.
1. On the remote, press and hold the MENU/RIGHT button
for 2 seconds to enter the menu.
2. Select ZWAVE > EXCLUDE.
3. On the shade, press and hold the program button for
3 seconds. When the shade LED flashes green, release
the button.
The remote’s screen will indicate that the shade has been removed from
the remote. The shade will jog.
Pairs the multi-channel remote with an existing shade network as an additional remote.
On the remote, press and hold the
MENU/RIGHT button to enter the menu.
3. Select ZWAVE > LEARN.
Factory reset Multi-Channel Remote Control
Restores the remote back to a factory
state by removing all memory of shade
and remote pairings from the remote.
1. On the remote, press and hold the
MENU/RIGHT button to enter the menu.
2. Select ZWAVE > RESET.
3. With LIKE NEW? selected, press and
hold the MENU/RIGHT button until the
screen no longer tells you to wait.
Please use this procedure only when the network primary controller is missing or otherwise inoperable.
Any button press will wake up the remote.
Associate: Pair remotes with your shades.
On the remote, press and hold the MENU/RIGHT button for 2 seconds to enter the menu.
2. Select ZWAVE > ASSOCIATE.
On the shade, press and hold the program button for 3 seconds. When the shade LED flashes green, release the button.
The shade will jog.
Find- Locates existing shades in a shade
network and adds the multi-channel
remote as an additional control.
Shift- Pairs the multi-channel remote with an
existing shade network as the primary
remote.
Clear Channels- Clear all your current channel assignments and
start over with assigning shades to channels, follow these steps.
1. On the remote, press and hold the MENU/RIGHT button for
2 seconds to enter the menu.
2. Select SHADE > CLR CHNLS > CONFIRM.
At this point, the shade menu is cleared. This means you can’t select a shade from the remote or assign shades to a channel until you find them again.
Please note that this is a user manual Multi-Channel Remote Control from Bali is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Multi-Channel Remote Control and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.