The following is an overview of the user manual for the Z-Wave product Bandi (BDS-301 Z)from BANDI. To view other Z-Wave products and manuals from BANDI follow that link.
Overview
Security
As a Z-Wave Plus certified product, Bandi supports Z-Wave S2 security. The following security modes are directly supported:
Features
BANDI describes Bandi as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Enter the application in the smart phone.
2. Touch the"" Add New Device"" in the screen of the smart phone.
3. Select""Switch"".
4. Press the top button gently on the switch for 3(three) seconds and then the status led will start to flash.
5. Then stop pressing the top button.
6. Then the status led will be turned off.
1. Enter the application in the smart phone.
2. Touch the"" Remove New Device"" in the screen of the smart phone.
3. Select""Switch"".
4. Press the top button gently on the switch for 3(three) seconds and then the status led will start to flash.
5. Then stop pressing the top button.
6. Then the status led will be turned on.
Factory reset Bandi
1. Press the top button on the switch for 10(ten) seconds.
2. Then the status led will be turned on.
*Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual Bandi from BANDI is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Bandi and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.