The following is an overview of the user manual for the Z-Wave product Simple Room Display (210001)from baseCON. To view other Z-Wave products and manuals from baseCON follow that link.
Overview
The room display can be used for various use cases. For example, an alarm function (window / door monitoring) can be realized via the room display. The buttons on the room display can be used to activate and deactivate the alarm function. In case of a triggered alarm, the room display can show the alarm with a visual and acoustic signal. It should be noted that the room display does not have its own intelligence, so the functionality must be realized via the Z-Wave controller. Other use cases are e.g. activate and deactivate scenarios, switch on and off a power module, reminder of appointments, medication,... .
Security
As a Z-Wave Plus certified product, Simple Room Display supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
baseCON describes Simple Room Display as having the following features:
- Z-Wave Scene Type
- Switch Type
- Color
- Communications Protocol
- Firmware updatable via a compatible Z-Wave gateway
- Sensors
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Inclusion
After power up the device (not included), the ex-/inclusion button lights permanently in color red.
To start the inclusion mode the ex-/inclusion button on Room Display must be pressed for at least 1.5 seconds.
If the time of 1.5 seconds is reached the segment starts to blink red.
During inclusion ex-/inclusion button lit white. Segment3 switched of and device sounds “dingdong” if device is completely entered the network.
Exclusion
The Room Display can be removed from the network with pressing the ex-/inclusion button.
The ex-/inclusion button on Room Display must be pressed for at least 5 seconds. If 5 seconds are reached the ex-/inclusion button starts to flash yellow. Release button to start exclusion. After successful removing the device reboots (flashing all 4 segments for 1 second in color white)
Factory reset Simple Room Display
Factory default Reset
The Room Display can be removed from the network. This can only be done within the first minute after plugging in the power plug. The function cannot be activated later.
1. For Device Reset unplug the device for 10 seconds.
2. Device plug in
3. Press button1 1x, button2 2x, button3 3x and button4 4x => segment4 is flashing in color magenta.
4. Press button4 1x
The device restarts now, sets all settings (brightness, volume, …) to default and flashing all 4 segments for 1 second with color white.
Please use this procedure only when the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual Simple Room Display from baseCON is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Simple Room Display and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.