The following is an overview of the user manual for the Z-Wave product Heimdall (Heimdall)from BTSTAR. To view other Z-Wave products and manuals from BTSTAR follow that link.
Overview
Support real-time control
Timing arrangement
Scenarios Design
Support real-time monitoring
Smart products including gateway/controller, siren, smart plug, door sensor, lights, door lock ..etc
Security
As a Z-Wave Plus certified product, Heimdall supports Z-Wave S2 security. The following security modes are directly supported:
Features
BTSTAR describes Heimdall as having the following features:
- Communications Connections
- Controller Supports Multiple Z-Wave Interfaces
- Firmware updatable via a compatible Z-Wave gateway
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
A. Ensure gateway connected, click “Remove” to Exclude devices, please flick the right button to excluded it according to the product manual.
B. After device Exclude show information , At the same time the
device is removed at the “Device” interface.
A. Ensure Gateway is connected, enter device page and click “Add” to include devices, please flick the right button to include it according to the product manual.
B. After device include show information (as attached photo), You can view the device at the “Device” interface
C. If cannot include the device in 60 seconds, please remove the device and
include it again.
D. In the process of inclusion, please note the In/Ex changes of gateway, lights flash
only when the gateway works properly.
Factory reset Heimdall
Click “Reset” , show “Proccessing…” to reset the Z-Wave network.Refer user manual page 12
Ensure the Gateway not included any device or Reset the Gateway.
You can review and control the device for learned Gateway.
Into the Learn Mode, show “Processing…” , operate another Controller into inclusion device mode, after the completion of the study to be prompted to inclusion success.
When you need initiate a replication of network information from the controller to another controller or want to receive network information, please enter ""include"" and ""learn mode""； Refer user manual page 11.
Please note that this is a user manual Heimdall from BTSTAR is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Heimdall and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.