Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

Intelligent Thermostat (B36-T10) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Intelligent Thermostat (B36-T10)from Building 36. To view other Z-Wave products and manuals from Building 36 follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Building 36 Intelligent Thermostat
SKU Code
B36-T10
Description
The Building 36 Intelligent Thermostat gives you remote access and control of your thermostat. Enjoy effortless energy management, climate and ambiance control, custom automation and measurable results. Create custom smart schedules that automate your thermostat. Receive critical temperature alerts to know instantly when your thermostat reaches preset limits. Save energy by using location-based automation to have your thermostat adjust itself while you're out.

This thermostat is part of an entire ecosystem of home automation products. It was built to provide a single integrated solution to give you more from your connected home.
Version #
1.0 was the version certified
Certification #
ZC10-14120002
Certified
2014-11-25T20:24:16.250458
Z-Wave Version
6.51.02

Security

As a Z-Wave Plus certified product, Intelligent Thermostat supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    Building 36 describes Intelligent Thermostat as having the following features:

    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    1. Put the thermostat in OFF mode (No mode icons are lit).
    2. Put the Z-Wave controller into add mode. Refer to the controller documentation for more information.
    3. Press and hold the DOWN button on the thermostat to begin inclusion. Release the button when the RADIO icon lights up.
    4. When the RADIO icon becomes solid, the thermostat has been added.

    1. Put the thermostat in OFF mode (No mode icons are lit).
    2. Press and hold the remove button on the Z-Wave controller. Refer to controller documentation for more information.
    3. Press and hold the DOWN button on the thermostat to enter exclusion mode. Release the button when the RADIO icon lights up.
    4. When the RADIO icon becomes solid the thermostat has now been successfully removed from the network.

    Factory reset Intelligent Thermostat

    Please use this procedure only when your primary controller is missing or otherwise inoperable.

    1. Put the thermostat in OFF mode (No mode icons are lit).
    2. Press and hold the UP button to show the firmware versions.
    3. Once the firmware versions are shown, press and hold the DOWN button to enter RST mode. The thermostat should display ""RST"".

    Please note that this is a user manual Intelligent Thermostat from Building 36 is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Intelligent Thermostat and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.