The following is an overview of the user manual for the Z-Wave product Temperature Sensor (B36-S10)from Building 36. To view other Z-Wave products and manuals from Building 36 follow that link.
Overview
Security
As a Z-Wave Plus certified product, Temperature Sensor supports Z-Wave S2 security. The following security modes are directly supported:
Features
Building 36 describes Temperature Sensor as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset Temperature Sensor
NOTE: Only reset the sensor to factory default when the primary controller is missing or inoperable.
Press and hold the button for 15 seconds. Release the button after 15 seconds and the LED will blink rapidly when the sensor has been reset to factory default.
The temperature sensor will send wake up notifications when the button is pressed and the temperature sensor is already included in a Z-Wave network. It also sends wake up notifications based at time intervals specified in the wake up set command.
Put the Z-Wave controller into add mode (refer to controller documentation for more information). Press the button on the sensor to add to the Z-Wave network. The LED on the sensor will go solid white when the sensor has been successfully added.
Put the Z-Wave controller into remove mode (refer to the controller documentation for more information). Press the button on the sensor to remove from the Z-Wave network. The LED on the sensor will blink white when the sensor has been successfully removed.
Please note that this is a user manual Temperature Sensor from Building 36 is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Temperature Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.