The following is an overview of the user manual for the Z-Wave product Door Sensor (51113)from CLEVERIO. To view other Z-Wave products and manuals from CLEVERIO follow that link.
Overview
Security
As a Z-Wave Plus certified product, Door Sensor supports Z-Wave S2 security. The following security modes are directly supported:
Features
CLEVERIO describes Door Sensor as having the following features:
- Battery Quantity
- Battery powered using AAA batteries
- Color
- Supported Notification Types
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset Door Sensor
- Long press Func_Button while installing batteries in HS1DS-Z
- Device Reset Locally notification is Transmitted
- Please use this procedure only when the network primary controller is missing or otherwise inoperable.
- Press a Func_Button 3 times quickly.
- If Exclusion Process is successful, Green led is Blinking 6 times, then turn off.
- Press a Func_Button 3 time in the Door Sensor, Green LED is Blinking 3 times within 1 second.
- If Inclusion Process is successful, Green led will turn off.
Please note that this is a user manual Door Sensor from CLEVERIO is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Door Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.