The following is an overview of the user manual for the Z-Wave product Motion Sensor (51111)from CLEVERIO. To view other Z-Wave products and manuals from CLEVERIO follow that link.
Overview
It’s suitable to be used for safety protection of residential, villas, factories, shopping malls, warehouses, office
buildings, banks, computer room and other places.
Security
As a Z-Wave Plus certified product, Motion Sensor supports Z-Wave S2 security. The following security modes are directly supported:
Features
CLEVERIO describes Motion Sensor as having the following features:
- Battery powered using CR123A/CR17335 batteries
- Supported Notification Types
- Color
- Communications Protocol
- Battery Quantity
- Sensors
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
-Press Func_Button 3 time in the motion sensor, Green LED is Blinking 3 times within 1 second.
-If Inclusion Process is successful, Green LED will turn off.
-Press Func_Button 3 times quickly.
-If Exclusion Process is successful, Green LED is Blinking 6 times, then turn off.
Factory reset Motion Sensor
-Long press Func_Button while installing batteries
-Device Reset Locally notification is Transmitted
-Please use this procedure only when the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual Motion Sensor from CLEVERIO is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Motion Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.