Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

Clamp Meter (CLMT-1ZW) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Clamp Meter (CLMT-1ZW)from Climax Technology. To view other Z-Wave products and manuals from Climax Technology follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Clamp Meter
SKU Code
CLMT-1ZW
Description
CL Meter is an energy metering device designed to measure, monitor, and report the energy consumption of an entire household or apartment building directly from the electric box or breaker panel, for users to look for energy-saving opportunities or provide tenant-specific billing. Installed directly in the home’s main circuit box, with the clamps attached to it, the CLMT-1ZW will monitor the total amount of electricity the entire home uses with accuracy and speed. With the CL Meter, users can easily track their power usage, allowing them to make the most out of reducing energy consumption and achieving greater energy efficiency.
Version #
HW: 255 FW: 1.29 was the version certified
Certification #
ZC10-17035457
Certified
2017-03-06T16:24:12.312787
Z-Wave Version
6.61.00

Security

As a Z-Wave Plus certified product, Clamp Meter supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    Climax Technology describes Clamp Meter as having the following features:

    • Supported Meter Type
    • Color
    • Firmware updatable via a compatible Z-Wave gateway
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    The device must be removed from existing Z-Wave network before being added into another.
    Exclusion Mode
    -Put the Z-Wave Gateway or Control Panel into Exclusion mode
    (please refer to the Z-Wave or control panel manual).
    -Within 1.5 seconds, press the Function Button 3 times and the
    device will be removed from the Z-Wave network.

    This product can be included and operated in any Z-Wave network with other Z-Wave certified devices from other manufactures and/or other applications. All non-battery operated nodes within the network will act as repeaters regardless of vendor to increase reliability of the network.
    -Plug in the AC Input cable into the socket to power on the Clamp
    Meter.
    -Put the Control Panel into Inclusion mode (please refer to the Z-
    Wave control panel manual).
    -Within 1.5 seconds, press the Function Button 3 times.
    -Refer to the operation manual of Z-Wave Gateway or Control Panel
    to complete the adding process.
    -If the device has already been added (included) into another Z-Wave
    Gateway/Control Panel, or if the device is unable to be added into
    the current Z-Wave Gateway/Control Panel, try removing it first (see
    Removing Device).

    Factory reset Clamp Meter

    Factory resetting the device will restore it to factory default settings (i.e. not included into any Z-Wave network). Please only use this procedure if the Z-Wave Gateway or Control Panel is lost or otherwise inoperable.
    -Press and hold the Function Button of the device for 10 seconds to
    factory reset.

    Please note that this is a user manual Clamp Meter from Climax Technology is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Clamp Meter and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.