The following is an overview of the user manual for the Z-Wave product Outdoor Siren (BX-32ZW)from Climax Technology. To view other Z-Wave products and manuals from Climax Technology follow that link.
Overview
The multi-functional outdoor bell box can work with the Control Panel to emit entry, exit delay, and low battery beeps. The BX-32ZW generates unique alarm sounds for fire and burglary to inform users of the type of danger at hand. It’s tamper-deterrent feature protects against unauthorized removal and sabotage. The BX-32ZW is compatible with other manufacturers’ Z-Wave alarm systems.
Security
As a Z-Wave Plus certified product, Outdoor Siren supports Z-Wave S2 security. The following security modes are directly supported:
Features
Climax Technology describes Outdoor Siren as having the following features:
- Battery Quantity
- Battery powered using 1.5V D-Cell Alkaline batteries
- Outdoor Use
- Firmware updatable via a compatible Z-Wave gateway
- IP (Ingress Protection) Rated
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
The Bellbox must be removed from existing Z-Wave network before being included into another. There are two methods available to exclude a device.
Exclusion Mode
- Put the Z-Wave gateway or control panel into Exclusion mode
(please refer to the Z-Wave gateway or control panel manual).
- Within 1.5 seconds, press the Function Button 3 times and the
Bellbox will be removed from the Z-Wave network.
This product can be included and operated in any Z-Wave network with other Z-Wave certified devices from other manufactures and/or other applications. All non-battery operated nodes within the network will act as repeaters regardless of vendor to increase reliability of the network.
- Insert the two 1.5V D-Cell alkaline batteries into the battery
compartment connecting the correct polarity as shown on the
battery compartment lid.
- The Bellbox will emit a 2-tone beep.
Put the Z-Wave gateway or control panel into Inclusion mode (please
refer to the Z-Wave gateway or control panel manual).
- Within 1.5 seconds, press the Function Button 3 times.
- Refer to the operation manual of the Z-Wave Gateway or Control
Panel to complete the adding process.
- If the sensor has already been added (included) into another Z-Wave
Gateway/Control Panel, or if the sensor is unable to be added into
the current Z-Wave Gateway/Control Panel, please exclude it first
(see Removing Device) before attempting to include it into the
current Z-Wave Gateway/Control Panel.
Factory reset Outdoor Siren
Factory Reset
(Only use factory reset when network Control Panel/Gateway is missing or inoperable).
- Press and hold the Function button of the Bellbox for 10 seconds to
factory reset with all LED flashes once.
Factory resetting the Bellbox will restore it to factory default
settings (excluded from the Z-Wave network). The Z-Wave gateway
or control panel will still keep its Z-Wave settings. Please refer to
the gateway or control panel manual on how to remove the
Bellbox’s Z-Wave settings.
Please note that this is a user manual Outdoor Siren from Climax Technology is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Outdoor Siren and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.