The following is an overview of the user manual for the Z-Wave product Power Switch Meter (PSM-29ZW)from Climax Technology. To view other Z-Wave products and manuals from Climax Technology follow that link.
Overview
Security
As a Z-Wave Plus certified product, Power Switch Meter supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
Climax Technology describes Power Switch Meter as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Switch Load Capacity Watts
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Put the Z-Wave Gateway or Control Panel into Exclusion mode (please refer to the Z-Wave Gateway or Control Panel manual).
2. Within 1.5 seconds, press the Function Button 3 times and the device will be removed from the Z-Wave network.
1. Plug the Power Switch Meter into a power outlet.
2. Put the Z-Wave Gateway or Control Panel into Inclusion mode (please refer to the Z-Wave Gateway or Control Panel manual).
3. Within 1.5 seconds, press the Function Button 3 times.
4. Refer to the operation manual of the Z-Wave Gateway or Control Panel to complete the adding process.
5. If the device has already been added (included) into another Z-Wave Gateway/Control Panel, or if the device is unable to be added into the current Z-Wave Gateway/Control Panel, please exclude it first (see Removing Device) before attempting to include it into the current Z-Wave Gateway/Control Panel.
SmartStart location
SmartStart QR code's location as follows: The DSK information is stored in the QR code format that is printed on a label and adhered to the front side of the device, as example shown on the right hand side.
Factory reset Power Switch Meter
*. Press and hold the Function Button of the device for 10 seconds to factory reset.
1. Factory resetting the device will restore it to factory default settings (excluded from the Z-Wave network). The Z-Wave Gateway or Control Panel will still keep its Z-Wave settings. Please refer to the Gateway or Control Panel manual on how to remove the device’s Z-Wave settings.
2. Factory resetting the device will also clear all accumulated power data.
3. Before you remove or factory reset the Power Switch Meter, please ensure that the device DSK information has been removed or does not exist in the gateway. If you remove or factory reset the device, but its DSK still exists in the gateway, the gateway will automatically include the device again.
Please note that this is a user manual Power Switch Meter from Climax Technology is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Power Switch Meter and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.