The following is an overview of the user manual for the Z-Wave product Z-Wave Router / USB Power Adaptor (RMB-35ZW)from Climax Technology. To view other Z-Wave products and manuals from Climax Technology follow that link.
Overview
Z-Wave is a wireless communication protocol that uses a low-power RF radio. By taking advantage of the Z-Wave mesh network, commands can be transmitted to their destination via intermediary “listening” Z-Wave products.
Security
As a Z-Wave Plus certified product, Z-Wave Router / USB Power Adaptor supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
Climax Technology describes Z-Wave Router / USB Power Adaptor as having the following features:
- Battery powered using NI-MH 200mAh*3 batteries
- Firmware updatable via a compatible Z-Wave gateway
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: The DSK information is stored in the QR code format that is printed on a label and adhered to the front side of the device, as example shown on the right hand side.
1. Scan the QR Code sticker on the Router to obtain DSK and transfer to the Z-Wave gateway.
2. Plug the Router into a power outlet, a SmartStart inclusion request will be automatically sent to the gateway.
3. The gateway will automatically include the device upon recognition of the device by matching the inclusion request with the DSK obtained .
1. Connect the Router into the power socket to power on.
2. Put the Z-Wave Gateway or Control Panel into Inclusion mode (please refer to the Z-Wave Gateway or Control Panel manual).
3. Within 1.5 seconds, press the Function Button 3 times.
4. Refer to the operation manual of the Z-Wave Gateway or Control Panel to complete the adding process.
5. If the sensor has already been added (included) into another Z-Wave Gateway/Control Panel, or if the sensor is unable to be added into the current Z-Wave Gateway/Control Panel, please exclude it first (see Removing Device) before attempting to include it into the current Z-Wave Gateway/Control Panel.
1. Put the Z-Wave Gateway or Control Panel into Exclusion mode (please refer to the Z-Wave Gateway or Control Panel manual).
2. Within 1.5 seconds, press the Function Button 3 times and the Router will be removed from the Z-Wave network.
Factory reset Z-Wave Router / USB Power Adaptor
(Only use factory reset when network Control Panel/Gateway is missing or inoperable).
Press and hold the Function Button for 10 seconds to factory reset.
Always On Slave
Please note that this is a user manual Z-Wave Router / USB Power Adaptor from Climax Technology is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Router / USB Power Adaptor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.