The following is an overview of the user manual for the Z-Wave product 2-Channel Dimmer (CT2D)from CONFIO. To view other Z-Wave products and manuals from CONFIO follow that link.
Overview
Both channels/loads operate independently, Two corresponding local switches and potentiometers are available to directly control these channels irrespective of inclusion state. Local switches can be configured to different modes.
CT2D Channel #1: TRIAC/FET based edge control dimming. This channel can be operated in two modes LEC/TEC respectively.
CT2D Channel #2: PWM dimmer. This channel is capable of dimming LED lamps which have PWM dimming capabilities. This needs a PWM enabled LED driver.
CT2D can be used out of the box and needs no configuration. However, it supports different configuration parameters that extend its functionality
Security
As a Z-Wave Plus certified product, 2-Channel Dimmer supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
CONFIO describes 2-Channel Dimmer as having the following features:
- Loads Controlled
- Switch Load Capacity Watts
- Neutral Wire Required
- Firmware updatable via a compatible Z-Wave gateway
- Electric Load Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Inclusion mode can be invoked by a one-time short press of NODE_INFO key.
User indication: Blinking of green LED shows successful inclusion.
Exclusion mode can be invoked by a one-time press of NODE_INFO key.
User indication: Blinking of red LED shows successful exclusion.
Factory reset 2-Channel Dimmer
Device Reset can be invoked by press & hold NODE_INFO key for more than 10 seconds, User indication: Blinking of red LED shows a successful reset.
The controller will be informed about this event via COMMAND_CLASS_DEVICE_RESET_LOCALLY command, Once the device resets, it will no longer be a part of the Z-Wave network and all the user configuration parameters are set to their default values.
Note: RED led also flash after 5 seconds for mode change. Continue to hold NODE_INFO key for 10 seconds to reset the device. Please use this procedure only when the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual 2-Channel Dimmer from CONFIO is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have 2-Channel Dimmer and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.