The following is an overview of the user manual for the Z-Wave product Module (7440-MC-FS)from Connectair. To view other Z-Wave products and manuals from Connectair follow that link.
Overview
With the Connectair Module integrated into your Convectair heater, adjust the comfort of your home according to your schedule and lifestyle, all at a distance and at all times. Once included in the ecosystem, the Connectair app and Controller allow you to control and make changes to your heating mode. Set your heaters to Comfort, Eco, Frost-protection or Standby mode, and then adjust the temperature setting as needed.
It is also possible to locally change the set temperature of your heater by using the + and - buttons directly on the Connectair Module.
Convectair compatible heaters
The Connectair Module is currently compatible with Allegro II models. The Apéro (240V only) can also receive the information of the Module if it is connected by pilot wire to an Allegro II having the Module included.
An open and flexible ecosystem
The Connectair Module uses Z-Wave Plus technology, the most widely used wireless communication system in the world of connected objects. It is through this protocol that the Module communicates with the Connectair Controller.
Secure
Z-Wave Plus, the protocol used by Connectair is highly secure to protect communication between connected devices and the Controller. Moreover, Connectair uses the latest version of the Z-Wave library, the most secure on the market.
The Connectair Module is equipped with a manual switch to prevent anyone from remotely shutting down the Convectair heaters. When turned on, this switch blocks the Standby mode.
Inclusion
The inclusion steps for the Module are simple and intuitive. In three clicks, your Module will be ready to be included into the ecosystem.
Once included in the ecosystem, your heater will be controllable like the rest of the connected devices and subject to ecosystem features such as the scenarios.
The Convectair warranty
• 2 years against all manufacturing defects
Due to our commitment to research and development, we reserve the right to change specifications without notice.
Security
As a Z-Wave Plus certified product, Module supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
Connectair describes Module as having the following features:
- Color
- Thermostat Modes
- Thermostat Power Source
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Start the adding process on the controller side
Once started, start the adding process on the Connectair module by pressing 3 times the Z-Wave button, located between the plus and the minus button, using the included tool.
When added, the LED will turn off
Start the removing process on the controller side
Once started, put the device in ""learn mode"" by pressing 3 times on the Z-Wave button, located between the plus and the minus button, using the included tool.
When removed, the LED will turn on
Factory reset Module
Please use this procedure only when the network primary controller is missing or otherwise inoperable
Hold the Z-Wave button for about ten seconds
If it was included, the LED will turn back on when reset is done
Please note that this is a user manual Module from Connectair is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Module and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.